Using the 3.3v serial port via the pin headers (exact location depends on hardware version) will get u-boot output and, when configured, a Linux kernel console. ![]() USB keyboards and HDMI displays should work, though some issues have been reported (see Troubleshooting below). It takes approximately 1 minute to boot a Pi 3B. kernelModules = } Notes about the boot process Using the 64-bit AArch64 image is highly recommended, as the availability of binaries is much better and allows the use of the 64-bit instruction set.įor the UART console, edit /extlinux/nf on the boot partition of the SD card to set console=ttyS1,115200n8 in the kernel boot parameters, and use the following GPIO Pins with an USB-TTL connector:īoot. Use as armv7 is community supported.įirst follow the generic installation steps to get the installer image and install using the installation and configuration steps.īoth the AArch64 and ARMv7 images boot out-of-the-box. The Raspberry Pi 3 Family is only supported as AArch64. ![]() This could reduce compatibility with some add-on boards or third-party libraries. The default Linux kernel in use, is the mainline Linux kernel, and not the Raspberry Pi Foundation's fork.
0 Comments
Leave a Reply. |